FS Tool Series L03TK
FS Tool Carbide Tipped Saw Blade: Thin Kerf Cross Cut Saw Blades, ATB

Design:
• Tooth configuration: ATB
• Cutting material: TC
• Expansion slots: CU plugged

Application:
• For cross cutting and ripping dry soft and hardwoods, plywood and veneered plywoods
• Not recommended to cut stock over ¾” without the use of stabilizer flanges
FS Tool Series L05
FS Tool Carbide Tipped Saw Blade: Thin Kerf Saw Blades, TCG

Design:
• Tooth configuration: refer to chart below (grind)
• Cutting material: TC
• Expansion slots: CU plugged
• Very stable body minimizes run-out

Application:
• For fine cross cuts in veneered panels, expensive woods and sheets, thin plexiglass, masonite and plastics
• On table saws, sliding table saws and vertical panel sizing saws
FS Tool Series L15
FS Tool Carbide Tipped Saw Blade: Thin Rim Saw Blades, ATB

Design:
• Tooth configuration: ATB
• Cutting material: TC
• Expansion slots: CU plugged
• Thin rimmed body (on left side) allows for thin kerf at teeth and stability during cutting operation

Application:
• For fine cross cuts in veneered panels, expensive woods and sheets, thin plexiglass, masonite and plastics
• On table saws and sliding table saws
FS Tool Series L16
FS Tool Carbide Tipped Saw Blade: Thin Rim Saw Blades, TC2

Design:
• Tooth configuration: TC2
• Cutting material: TC
• Expansion slots: CU plugged
• Thin rimmed body (on left side) allows for thin kerf at teeth and stability during cutting operation

Application:
• For thin cross cuts in acrylic sheets, thin plexiglass, masonite and plastics
• On table saws and sliding table saws